Z519C, Z520C, Z520Ci, Z521C, Z522D - Ranger boats Z-Comanche Owner's/Operator's Manual

Wake and Sleep Mode
Sleep mode will cause the key pad to reduce power consumption by reducing live circuits. For the key pad
to enter the sleep mode it will require the main 30 amp breaker to be on and no switch activity for four hours, all
pumps turned off, and the ignition is off. When the key pad is in the sleep mode the accessories will not function.
To wake the key pad you must press one of the following functions: Start, Stop, 1, 2, 3, 4, or any button on the
bow touch pad with the main breaker set to the on position. After pressing one of the buttons you can then proceed
with your desired operation. While the key pad is in the sleep mode the float switch to the bilge still has power and
if the float switch is triggered it will wake the key pad. If the bilge pumps, live well pumps, or ignition is left on, the
system will not enter sleep mode.
Keyless Ignition
Starting the engine:
• Turn the main breaker to on.
• Press on the buttons required to wake the system.
• Enter the following user code unless it has not been changed in order "1-2-3-4".
• Press "Start". After pressing start the LED by the 1 button will light putting the keyless ignition switch in
accessory mode.
• Press the "Start" button a second time holding it for two seconds and the engine will crank.
• Once the engine has started, release the "Start" button.
• To stop the engine, press the stop button.
• To lock the system after stopping the engine, enter the user code "1-2-3-4" and then press "Stop".
To choke a carbureted engine:
Press the "Start" and the "1" key simultaneously while starting the engine.
To change the user code:
Wake the system up by pressing one of the buttons described above. Enter in the current user code followed
by pressing the "1" and "4" buttons at the same time. You will have 2 seconds after entering in the user code to
press the "1" and "4" buttons.
"1-2-3-4"
Leave the "1&4" depressed until the 1 LED flashes. If the 1 LED does not flash after holding the "1&4" down
for 5 seconds, one of the following may have happened: the user code was not entered correctly, or 1 and 4 were
not depressed at the same time, or too much time elapsed after entering in the user code before pressing the 1
and 4. Turn the system off by entering in the code and press stop. After the LED is not lit by the stop button, start
at the beginning of this section again.
After the flashing of the stop LED is obtained, enter in the new four digit number followed by the start button,
and then re-enter the four digit number followed by the start button.
"X-X-X-X"
After pressing the start button the second time the system will go into accessory mode. If it does not enter
accessory mode, type the current user code in and press the stop button, then proceed at the beginning of this
section.
Z519c, Z520c, Z521c, Z520ci, Z522d
"1&4"
"Start" "X-X-X-X"
Electrical Systems
"Start"
55