Attach Balance Joint (To Upper Yoke); 2A. Attach Extension Tube (To Balance Joint); 2B. Attach Extension Tube (To Upper Yoke) - BIG ASS FANS Pivot Installation Manual

1. Attach balance joint (to upper yoke)

If the fan will not be pivoted, it is not necessary to install the balance joint. Skip this step and proceed to Step 2b.
Fasten the balance joint to the upper yoke (already attached to mounting
structure) using the Balance/Pivot Hardware. Hand-tighten the bolts.
The fan's balanced position can change depending on the pivot angle
of the fan or the angle of the roof. For this reason, do not fully tighten
these bolts until the fan is completely assembled.
Balance/Pivot Hardware:
a. (2) 1/2-13 x 5'' GR 8 Bolt
b. (4) 1/2'' Flat Washer
c. (2) 1/2-13 Nylock Nut

2a. Attach extension tube (to balance joint)

Fasten the extension tube to the balance joint with the Extension
Tube Hardware. Hand-tighten the bolts.
The fan's balanced position can change depending on the pivot
angle of the fan or the angle of the roof. For this reason, do not fully
tighten these bolts until the fan is completely assembled.
Proceed to Step 3.
Extension Tube Hardware:
a. (2) 1/2-13 x 4-1/2'' GR 8 Bolt
b. (4) 1/2'' Flat Washer
c. (2) 1/2-13 Nylock Nut

2b. Attach extension tube (to upper yoke)

Fasten the extension tube to the upper yoke with the Extension Tube
Hardware.
Before tightening the bolts, allow the extension tube to hang freely and
balance itself. Tighten the bolts to 40 ft·lb (54.2 N·m) using a torque
wrench and 3/4" socket.
Extension Tube Hardware:
a. (2) 1/2-13 x 4-1/2'' GR 8 Bolt
b. (4) 1/2'' Flat Washer
c. (2) 1/2-13 Nylock Nut
HANGING THE FAN
ATTENTION
WWW.BIGASSSOLUTIONS.COM © 2015 DELTA T CORP.
b
c
c
b
c
b
ALL RIGHTS RESERVED.
a
b
b
a
b
a
13