Yel; Wiring: 100–125/200–250 V Single-Phase Fan Controllers - BIG ASS FANS Pivot Installation Manual

Wiring: 100–125/200–250 V, single-phase fan controllers
WARNING: Wait three minutes after disconnecting before servicing!
WARNING: Improper installation can cause electric shock or damage to the motor and controller. A
qualified electrician should perform the installation.
The diagrams below shows wiring option for a 100–125/200–250 V, 1 Φ fan controller. See "Power Requirements
for Fan Controllers" for detailed power requirements.
Wiring for 200–250 V, 1 Φ, 50/60 Hz
fan controllers
The neutral terminal is not used when wiring the fan
controller for 200–250 V, 1 Φ. A disconnect and EMI
filter are included with this fan controller.
Note: This fan controller does not contain fusing!
Power must be supplied to this controller via
a dedicated circuit breaker or properly fused
disconnect!
Optional wiring for 100–125 V, 1 Φ, 50/60 Hz
fan controllers
The L2 terminal is not used when wiring the fan
controller for 100–125 V, 1 Φ. A disconnect is included
with this fan controller.
Note: This fan controller does not contain fusing!
Power must be supplied to this controller via
a dedicated circuit breaker or properly fused
disconnect!
WWW.BIGASSSOLUTIONS.COM © 2015 DELTA T CORP.
1 2 5 6 1 2 5 6 25 4 11 25 4 11
PE
U V W
/T1 /T2 /T3
BLK GRN/YEL
RED
AC Input Wiring
2W plus GND
1 2 5 6 1 2 5 6 25 4 11 25 4 11
PE
U V W
/T1 /T2 /T3
BLK GRN/YEL
WHT
AC Input Wiring
2W plus GND
ALL RIGHTS RESERVED.
13A13B13C 14 30 16 17 13A13B13C 14 30 16 17
L1
L2
L1 L2 L3
N
RED GRN/

YEL

BLK BLU
Motor Output Wiring
3W plus GND
13A13B13C 14 30 16 17 13A13B13C 14 30 16 17
L1
L2
L1 L2 L3
N
RED GRN/
YEL
BLK BLU
Motor Output Wiring
3W plus GND
29