Using A Patch Chain To Select Patches; Erasing A Patch Chain - Roland Octapad SPD-20X Owner's Manual

Using a Patch Chain to Select Patches

Here's how to step through the Patches in a Patch Chain.
1
A Patch Chain which does not contain any data will not be displayed in the Play mode.
NOTE
2
After the last Patch in the Chain, you will return to the first Patch.
MEMO
A footswitch connected to the FOOT SW jack can also be used to select Patches.
3
4

Erasing a Patch Chain

Here's how to erase the current Patch Chain settings
1
2
3
4
If you don't want to clear chains, select No and then press [All/ENTER]
NOTE
After all chains are cleared, the Patch Chain cannot be used, even if you press [PATCH CHAIN] in the
Play mode.
In the Play mode, press [CHAIN] to select a Chain (A, B, C, D, E, F, G, H).
Each time you press PATCH/VALUE [-] or [+] the next Patch in the Chain
will be selected.
Use [ ] or [ ] to switch between different Chains.
Press [PATCH CHAIN] again to return to the Play mode.
In the Edit mode, press [CHAIN].
Without any operation, press [ALL/ENTER] directly. The following
display will appear.
Clear Chain Set
Use PATCH/VALUE [-] or [+] to select 'Yes' .
Press [ALL/ENTER] to confirm. All the Chains will be cleared.
Sure? No
2
39