Installing Unit Ventilator End Panels - Daikin AVV Installation And Maintenance Manual

Installing Unit Ventilator End Panels:

See Figure 130. Accessory end panels are shipped
separately with hardware and kickplate, or simulated
kickplate adhesive tape used on 16⅝" units (only). Align
each end panel with the top and front edges of the unit
ventilator. Attach each end panel to the unit ventilator
using the hardware provided.
Figure 130: Install End Panels
30"
(762mm)
27 / "
7
8
(708mm)
Figure 131: Install End Panels With Provided Hardware (1"
End Panel Shown)
Screws
(insert through upper mounting holes inside unit end
compartment, and thread into tinnerman clips on end panel)
Tinnerman Clips
www.DaikinApplied.com
1" END PANEL
Tinnerman Clips
End Panel w/Cut out
Screws
(insert through end
panel and thread into
tinnerman clips on unit
subbase)
71
Figure 132: Install End Panels With Provided Hardware (6"
End Panel Shown)
1/4-20 x 1/2 Screw & 1/4 Flat Washer
1/4-20 Tinnerman Nut, Clip
Over Lower Hole in Unit
Corner Angle.
1/4-20 x 1/2 Screw & 1/4 Flat Washer
Position (YC-1934) bracket on wall so angle is 5"
1 .
from end of unit and near bottom
Mark and drill required hole for fastening device (not
2 .
included).
Attach bracket to wall.
3 .
Attach end panel. Bracket should prevent movement
4 .
of end panel toward end of unit when pressure is
applied to end panel, readjust bracket if necessary.
1/4-20 Tinnerman Nut,
Clip on End Panel
End Panel
5"
YC-1934
(Figure 132).
IM 817-7