Table of Contents
Advertisement
Terminal ELITE 770
III- PROCEDURES OF INSTALLATION
After having made the connections previously described, the operator can switch the
terminal on. Before doing this, the operator is obliged to enter all general data at the
terminal level.
1-
Configuring Radio Link
IMPORTANT NOTE : The following configuration is not necessary for a
single configuration (one base, one terminal), as it has been carried out
during production.
It is necessary only if you attempt to add a terminal on a previously purchased base.
This procedure, if failed, can provoke malfunction of other terminals connected to
your base. In case you are not sure to carry it out properly, or if it does not work
properly, call your retailer, who has powerful tools to configure both terminals and
base.
The LAN can not support more than 5 terminals without reconfiguring base. In case
you need 6 to 10 terminals on the same base, call your retailer, who is able to
configure properly the base.
• The link between the base and the terminals is coded from the related serial
numbers. This means that both terminals and base must know the serial number
of other components in the LAN.
• The base is able to find terminals identifiers at the first radio connection after
power-on. You don't need to configure it.
• The terminal must be configured in order to know the number of the base where
it will have to connect. In the menu « INPUT BASE # » under « SYSTEM
MENU », validate. The terminal then displays « LAN CONFIG. ». Enter the
code 2049, then validate. The terminal displays then the maximum number of
terminals. If your base is a 'standard' one, enter 5, then validate, else validate
without modification. The base's serial number is then displayed. This number
correspond to the number printed on the back of the base. Enter it, followed by
the VAL key.
• Your terminal is now configured. You can test it by printing a configuration
receipt (system menu, configuration), that must indicate the number of terminals
and the base serial number.
• In case the message 'Absent base ! ' is printed, the base serial number is not
correct.
• In case the message « FULL » is displayed, the number of terminals is no t
correct, or your base don't support an other terminal.
16
Advertisement
Table of Contents
