Winding The Bobbin - JUKI TL-2200QVP Instruction Manual

6
7
Thread passage
Thread tension
spring
10cm
* The bobbin should run clockwise.
8
Upon completion of winding the bobbin.
■
Return the bobbin presser to its home position. Take out the bobbin.
Trim the thread with the thread cutting knife.
Loading the bobbin into the bobbin case.
■
Snap in the bobbin case latch, and put the bobbin into the bobbin case so that
the bobbin runs clockwise.
Passing the thread through the slit of the bobbin case, continue passing it under
the thread tension spring, and pull out the thread open end about 10cm from the
bobbin case.
CAUTION
Turn OFF the power switch.
Set the bobbin in the sewing machine.
■
Insert the bobbin case fully into the hook, and close the bobbin case latch.
Close the hook cover.
– 20 –