JUKI TL-2200QVP Instruction Manual page 18

1
Stoke is
increased
Stroke is
decreased
1
2
3
1
Handwheel
■
1
2
2
A
B
C
Upper position: Stroke is
1 to 3 mm
Lower position: Stroke is
3 to 5 mm
CAUTION
Keep hand away from the handwheel while the sewing machine is
running.
Push and turn the hand pulley to turn the main shaft.
Turn on the power switch. White marker dot (A) on the handwheel
is brought to the right front as observed from just beside.
White marker dot (A) is in the front side: The thread take-up lever
comes up to its upper end.
Green marker dot (B) is in the front side: Not used
Red marker dot (C) is in the front side: It is used as the marker
dot at the time of lubricating.
– 17 –
Adjusting the presser foot
■
stroke
It is possible to adjust the presser
foot stroke.
Remove presser regulator cover.
Loosen nut . Shift block
1
to increase the stroke, or downward
to decrease it.
To increase the stroke more, change
the position of setscrew
arm to the lower position (stroke: 3
to 5 mm). The setscrew has been
factory-set at the upper position
(stroke: 1 to 3 mm) at the time of
shipment.
After the completion of the
adjustment, install the presser
regulator cover which you have
removed before the adjustment.
CAUTION
When the stroke is changed, the
clearance between the presser foot
and the throat plate will change.
Re-adjust the presser foot height to
a value which matches the material
thickness.
upward
2
of the link
3