Troubles And Corrective Measures - JUKI TL-2200QVP Instruction Manual

Troubles and Corrective Measures

If sewing difficulties occur, make sure the instructions are correctly followed. If a problem still exists, the reminders below
help to solve it.
Troubles
1. The needle is bent or the needle point
Stitches are
2. The needle has not been attached to
skipped.
1. The machine head has been threaded
2. The needle thread tension is too high
Needle thread
3. The needle is bent or the needle point
breaks.
4. The needle is not suited to the thread
1. The bobbin thread tension is too high.
2. The rubbing of the bobbin case spring
The bobbin
thread breaks.
3. Scratches on the needle hole in the
1. The needle is bent or has been
The needle
2. The needle hits the throat plate or the
breaks.
1. The tension of the needle thread is
Stitches are
2. When the combination of the needle
puckered.
3. The needle is too thick for the material.
Stitch
1. The tension of the needle thread is
performance
is bad.
The rotation noise
1. Thread wastes accumulate in the
is too heavy or
too high.
The handwheel
1. The thread is entangled and caught in
does not rotate
smoothly or does
not turn.
1. Remaining length of thread is shorter.
The sewing
machine cannot
perform sewing at
the beginning of
sewing.
2. Back tacking has not been carried out.
Case
is blunted.
the needle bar properly.
incorrectly.
or low.
is blunted.
used.
has produced a slot.
throat plate.
installed improperly.
presser foot.
not balanced with that of the bobbin
thread.
and the thread is improper.
not balanced with that of the bobbin
thread.
hook.
the hook.
Corrective measures
· Replace the needle.
· Attach the needle properly to the needle bar.
· Correct the threading.
· Properly adjust the thread tension.
· Replace the needle.
· Replace the needle by the one suited to the
thread used.
· Decrease the tension.
· Replace the bobbin case.
· Replace the throat plate.
· Replace or correctly attach the needle.
· Correctly position the needle, throat plate, or
presser foot.
· Balance the tension.
· Properly correct the combination of needle
and the thread.
· Replace the needle by the one suited to the
material.
· Balance the tensions.
· Clean up the sewing machine.
· Lubricate the hook, strongly turn the
handwheel clockwise and counterclockwise
several times, then remove the thread
caught in the hook.
· Loosen the tension controller No. 1 (turn to
the left) to increase the remaining length of
thread after automatic thread trimming.
· Draw thread through the needle eyelet to
adjust the remaining length of thread to
approximately 5 cm.
· Be sure to carry out back tacking by several
stitches at the beginning of sewing.
– 27 –
Page
26
26
23
24
26
26
24
-
-
26
-
24
25
25
24
27
-
25
-
25