HIOS HSF-10 Instruction Manual page 9

4-5 Adjusting the height of the brushes
No adjustment is required if the brushes rotate at a height where they come in contact with the screw heads going into the rail
groove when the power is switch on.
• Turn the power OFF if the height of the brushes requires adjustment.
• If adjustment is required, loosen the brush height adjustment screw (Image 4-1).
Move the brushes by hand and make adjustments by checking that the head of the screws entering the rail groove come in
contact with the brushes (Image 4-2).
• If the brushes are set too high, misaligned screws may not be swept up.
• If the brushes are set too low, the screws may be thrown to one side, or the brushes may not rotate.
Brush height adjustment screw
4-1
Image 4
Screws used
- 8 -
Brush
4-2