HIOS HSF-10 Instruction Manual page 11

4-5-2 Adjusting the height of the passing plate/holding plate
• The passing plate/holding plate are mounted to the rail (Image 8).
• The passing plate drops screws to be used into the passing plate section of the rail groove. Adjust the height of the passing plate
mounting screw to ensure that the gap in the passing plate is sufficient.
Screws can become easily jammed if this gap is too large. If there is no gap, the screws cannot pass through.
The ideal gap is one that allows the screws to just pass through.
A passing plate compatible with specially shaped screws, such as those with low heads, is available.
A new passing plate can be designed upon request if details of the screws to be used, or their dimensions, are provided.
(Please consult the store of purchase)
Holding plate
Holding plate mounting
screw
Passing plate mount-
ing screw
Image 8
Passing plate
- 10 -
Passing plate
Screw to be used
Image 9