HIOS HSF-10 Instruction Manual page 10

4-5-1 Adjusting the height of the passing plate/holding plate (how to remove the rail)
• Adjustment of the passing plate/holding plate is required if screws become jammed at the front of the screw hopper.
• Ensure that screws within the device are all removed before removing the rail (very important).
• Loosen the bit guide up/down adjustment screw (Image 5).
• Front/rear: loosen the rail mounting screw <do not loosen it too much> (Image 6).
• Pull the bit guide Assy upwards, and pull the rail out toward you (Image 7).
Front: rail
Mounting screw
Rear: Rail
Mounting screw
Image 6
- 9 -
Bit guide
Up/down
adjustment
screw
Image 5
Bit guide Assy
Rail
Image 7