HIOS HSF-10 Instruction Manual page 8

4-4 Check of operation
• If each section has been adjusted correctly, screws will be transported to the stopper section.
• Screws in the stopper section can be taken out with an electronic screw driver.
The screw driver should be vertical using the bit guide as a guide. The screw driver should then be briefly rotated and moved
horizontally to take the screw (Image 3).
• Do not apply excessive force when moving the screw driver horizontally (when matching the bit to the screw head).
Rotating the screw driver bit briefly makes it easier to line up the bit with the cross in the screw thread.
• Ensure that the screw driver bit matches that of the screw being used. (Refer to 4-1 Checking model number)
• Check the adjustment of each section if you believe the screw alignment and transport is not operating correctly.
the height of the brushes
• Place the screw driver verti-
cally and line up the bit with the
cross on the screw head.
• Move the screw driver towards
you into a horizontal position.
Image 3
- 7 -
4-5 Adjusting