Table of Contents
Advertisement
4-2 Basic operation
The driving motor repeats normal rotation and an inversion for about 2 seconds at a time, and the scooper carries screws
to the rail. The vibrator (solenoid) continuously sends screws to the front stopper to be picked up using the screwdriver.
Note:
If no screws are sent for approximately 10 seconds, vibration of a rail becomes stronger.
(The vibration sound, also, increases; however, this is not a problem.)
If no screws is not detected for about 20 more seconds, then the machine stops operating. When you want to start operation again,
turn the power switch OFF and ON again or a stopper is operated (extraction sensor perception).
4-3 Screw capacity
Placing too many screws into the hopper can adversely affect the alignment and transport of screws.
The image below (Image 2) is the maximum capacity and should be used as a guide to filling the hopper.
• Turn the power switch ON-OFF and ensure that the panning block is at its lowest position.
• Fill the hopper with screws up to a point approximately 2mm below the rail entrance.
• Check that the front of the sloped plate is not covered by screws.
• Constantly check that the optimum screw level is maintained during operation.
Ensure that the front of the sloped plate remains visible
- 6 -
Image 2
Advertisement
Table of Contents
