Table of Contents
Advertisement
D:\Sony\#Work\880191S_XM-GS6DSP(UC)\4733364111\4733364111XMGS6DSPUC\01GB-
XMGS6DSPUC\040CD.fm
010COV.book Page 10 Wednesday, November 1, 2017 4:27 PM
Input connections
Set the SELECT switch to the appropriate position
according to the speaker system.
2ch/BT mode and 6ch mode
Select "2ch/BT" or "6ch" mode depending on the
use/non-use of the DSP.
When selecting the "2ch/BT" mode, also select the
sensitivity "2V" or "5V" depending on the pre-
output level of your car audio unit.
Mode
For
using this unit as a 6ch amplifier (no
built-in DSP is used)*
the connections, see:
– " Line input connection (for
Subwoofer BTL system/6ch mode)"
(page 11).
– " High level input connection (for
Subwoofer BTL system/6ch mode)"
(page 12).
using this unit with a 3-way speaker
system. With this connection, a 3-ways
speaker system can be driven without
a crossover network. For details on the
connections, see:
– " Line input connection (for 3-way
speaker system/6ch mode)"
(page 11).
– " High level input connection (for
3-way speaker system/6ch mode)"
(page 13).
encoding 2ch input signals into 4.1ch
output signals (the built-in DSP is
used). For details on the connections,
see:
– " Line input connection (with DSP
enabled/2ch mode)" (page 10).
– " High level input connection (with
DSP enabled/2ch mode)" (page 12).
playing a BLUETOOTH device by
operating the "Sony | Music Center"
application. For details, see "Playing a
BLUETOOTH Device" (page 16).
Setting the sensitivity "2V" or "5V" of the
"2ch/BT" mode. Normally, use this unit
set to "2V".
When using a car audio unit with a high
pre-output level, set to "5V" if the sound
is distorted while increasing the volume.
10
GB
*1 While a bridged subwoofer connection is made, this
unit functions as a 5ch amplifier.
*2 When adjusting the volume balance of the front
speakers, rear speakers and subwoofer while the
unit is in 2ch mode (DSP mode), operate your
iPhone/Android smartphone to adjust the [Fader],
[Balance] and [Subwoofer Level] settings of the
"Sony | Music Center" application.
*3 The sound settings of the DSP (page 17) can be made
by the "Sony | Music Center" application on the
iPhone/Android smartphone. Before setting,
operate your iPhone/Android smartphone to
establish the BLUETOOTH connection with this unit
(page 15).
Line input connection
1
. For details on
(with DSP enabled/2ch mode)
With the speaker connection (page 14)
Notes
When making this connection, set the SELECT switch
to the "2V" position.
Set the SELECT switch to the "5V" position if the
sound is distorted when increasing the volume of the
car audio unit (only for car audio unit with a pre-
output level of 5 V).
masterpage: Left
XM-GS6DSP
4-733-364-11(1)
Advertisement
Table of Contents
