Table of Contents
Advertisement
D:\Sony\#Work\880191S_XM-GS6DSP(UC)\4733364111\4733364111XMGS6DSPUC\01GB-
XMGS6DSPUC\040CD.fm
010COV.book Page 7 Wednesday, November 1, 2017 4:27 PM
Installation
Select the mounting location where it is easy to
press the PAIRING button on the unit.
Choose the mounting location carefully so the
unit will not interfere with the normal movements
of the driver and it will not be exposed to direct
sunlight or hot air from the heater.
Do not mount the unit in a confined space such as
under the floor carpet that will obstruct heat
dissipation.
Mounting the unit
First, place the unit where you plan to install it, and
mark the positions of the 4 screw holes on a
mounting board (not supplied). Then drill a 3 mm
(
1
/
in) pilot hole at each mark and mount the unit
8
onto the board with the supplied mounting screws.
The mounting screws are all 20 mm (
so make sure that the mounting board is thicker
than 20 mm (
13
/
in).
16
Connections
Before making any connections, disconnect the
ground (earth) terminal of the car battery to avoid
short circuits.
Be sure to use speakers with an adequate power
rating. If you use small capacity speakers, they
may be damaged.
Do not connect the terminal of the speaker
system to the car chassis, and do not connect the
terminal of the right speaker with that of the
left speaker.
Install the input and output cords away from the
power supply wire. Running them close together
may generate interference noise.
This unit is a high powered amplifier. Therefore, it
may not perform to its full potential if used with
the speaker cords supplied with the car.
13
/
in) long,
If your car is equipped with a computer system for
16
navigation or some other purpose, do not remove
the ground (earth) wire from the car battery. If you
disconnect the wire, the computer memory may
be erased. To avoid short circuits when making
connections, disconnect the +12 V power supply
wire until all the other wires have been
connected.
Making the terminal connections
Pass the wires through the cap, connect the wires,
then cover the terminals with the cap.
Note
When you tighten a screw, be careful not to apply too
much torque as doing so may damage the screw (the
torque value should be less than 1 N•m).
masterpage: Right
7
GB
XM-GS6DSP
4-733-364-11(1)
Advertisement
Table of Contents
