Sony XM-CD61X Service Manual

QQ
3 7 63 1515 0

SERVICE MANUAL

Ver. 1.0 2004. 12
AUDIO POWER SPECIFICATIONS (US MODEL)
POWER OUTPUT AND TOTAL HARMONIC DISTORTION
XM-SD61X
300 watts minimum continuous average power into 4 ohms,
20 Hz to 200 Hz with no more than 1.0% total harmonic
distortion per Car Audio Ad Hoc Committee standards.
TE
XM-SD51X L 13942296513
250 watts minimum continuous average power into 4 ohms,
20 Hz to 200 Hz with no more than 1.0% total harmonic
distortion per Car Audio Ad Hoc Committee standards.
Other Specifications
Circuit system Class D Technology
Pulse power supply
Inputs RCA pin jacks
High level input connector
Outputs Speaker terminals
Through out pin jacks
Suitable speaker impedance
2 – 8 Ω
Maximum outputs XM-SD61X
800 W (at 4 Ω), 1,400 W (at 2 Ω)
XM-SD51X
600 W (at 4 Ω), 1,100 W (at 2 Ω)
Rated outputs (supply voltage at 14.4 V)
XM-SD61X
300 W RMS (20 – 200 Hz, 1.0% THD+N, at 4 Ω)
600 W RMS (20 – 200 Hz, 1.0% THD+N, at 2 Ω)
XM-SD51X
250 W RMS (20 – 200 Hz, 1.0% THD+N, at 4 Ω)
500 W RMS (20 – 200 Hz, 1.0% THD+N, at 2 Ω)
SN Ratio 76 dBA (Reference 1 W into 4 Ω)
Frequency response 5 – 300 Hz (
0.06% or less (at 100 Hz, 4 Ω)
Harmonic distortion
Input level adjustment range
0.3 – 6.0 V (RCA pin jacks)
6.5 – 16.0 V (High level input)
www
.
Sony Corporation
9-879-369-01
2004L04-1 e Vehicle Company
© 2004. 12 Published by Sony Engineering Corporation
http://www.xiaoyu163.com
XM-SD51X/SD61X
+0.5
dB)
–3
x ao
y
i
http://www.xiaoyu163.com
8
Photo: XM-SD61X
SPECIFICATIONS
Q Q
3 6 7 1 3
Sub-sonic filter
Low-pass filter
Low boost
Power requirements
Power supply voltage
Current drain
Dimensions
Mass
Supplied accessories
Design and specifications are subject to change without
notice.
MONAURAL POWER AMPLIFIER
u163
.
2 9 9 4 2 8
Canadian Model
AEP Model
1 5 0 5 8 2 9 9 4
15 Hz, –12 dB/oct
50 – 300 Hz, –12 dB/oct
0 – 10 dB (40 Hz)
12 V DC car battery
(negative ground)
10.5 – 16 V
XM-SD61X
at rated output: 75 A (at 2 Ω)
Remote input: 2 mA
XM-SD51X
at rated output: 55 A (at 2 Ω)
Remote input: 2 mA
Approx. 403 × 55 × 277 mm
× 2 × 11 in.) (w/h/d) not incl.
(15
7/8 1/4
projecting parts and controls
XM-SD61X
Approx. 4.6 kg (10 lb. 3 oz.) not incl. accessories
XM-SD51X
Approx. 4.5 kg (9 lb. 15 oz.) not incl. accessories
Mounting screws (4)
High level input cord (1)
Protection cap (1)
4P modularcable (1)
Remote level controller (1)
Screws (2)
m
co
9 9
US Model
UK Model
E Model
2 8 9 9
1