Table of Contents
Advertisement
D:\Sony\#Work\880191S_XM-GS6DSP(UC)\4733364111\4733364111XMGS6DSPUC\01GB-
XMGS6DSPUC\040CD.fm
010COV.book Page 8 Wednesday, November 1, 2017 4:27 PM
Power connections
Connect the +12 V power supply wire only after all
the other wires have been connected.
Be sure to connect the ground (earth) wire of the
unit securely to a metal point of the car. A loose
connection may cause a malfunction of the
amplifier.
When using a car audio unit without a remote
output (REMOTE OUT) for the amplifier, connect
the remote input (REM) terminal to the accessory
power supply.
Use a power supply wire with a fuse (60 A)
attached.
All power wires connected to the positive battery
post should be fused within 450 mm (17
the battery post, and before they pass through
any metal.
Make sure that the car's battery wires connected
to the car (ground (earth) to chassis) are of a wire
gauge at least equal to that of the main power
wire connected from the battery to the amplifier.
During full-power operation, a current of more
than 60 A will run through the system. Therefore,
make sure that the wires to be connected to the
+12 V and GND terminals of this unit are at least
8-Gauge (AWG-8) or have a sectional area of
more than 8 mm² (
11
/
in²).
32
8
GB
Making power connections
Power connection wires (not supplied) are required.
3
/
in) of
4
* Ground (earth) to chassis.
masterpage: Left
to a metal point of the car
less than 450 mm (17
3
/
in)
4
Fuse (60 A)
+12 V car battery
to the car's ACC power line
XM-GS6DSP
4-733-364-11(1)
Advertisement
Table of Contents
