Input Connections - Sony XM-GS4 Operating Instructions Manual

Hide thumbs Also See for XM-GS4:

Table of Contents

Available languages

Enlarged version

 Use a power supply wire with a fuse (60 A)

attached.

 All power wires connected to the positive battery

post should be fused within 450 mm (17

the battery post, and before they pass through

any metal.

 Make sure that the car's battery wires connected

to the car (ground (earth) to chassis) are of a wire

gauge at least equal to that of the main power

wire connected from the battery to the amplifier.

 During full-power operation, a current of more

than 60 A will run through the system. Therefore,

make sure that the wires to be connected to the

+12 V and GND terminals of this unit are at least 8-

Gauge (AWG-8) or have a sectional area of more

than 8 mm² (

in²).

Making power connections

Power connection wires (not supplied) are required.

less than 450 mm (17

Fuse (60 A)

*1 If you have the factory original or some other car

audio unit without a remote output for the amplifier,

connect the remote input (REM) terminal to the

accessory power supply. In High level input

connection, the car audio unit can also be activated

without need for REMOTE connection. However, this

function is not guaranteed for all car audio units.

*2 Ground (earth) to chassis.

in) of

to a metal point of the car

in)

+12 V car battery