Keithley 2601A User Manual page 39

Series 2600A System SourceMeter® Instruments User's Manual
NOTE The instrument's IP address can have leading zeros, but the
c.
d.
e.
f.
4. Change the subnet mask from within the LAN MENU:
a.
b.
c.
d.
e.
NOTE APPLY_SETTINGS must be used before changes to the IP address
Step 4: Connect the crossover cable from the instrument to the PC network interface card
Connect the supplied crossover cable between the computer's NIC card and the Ethernet
connector on the instrument's rear panel. There are multiple connectors on the Series 2600A rear
panel. Be sure to connect to the LAN connection port (see
NOTE Connect the crossover cable into the same PC Ethernet port that was
2600AS-900-01 Rev. B / September 2008
computer's cannot.
Use the navigation wheel to select and enter an appropriate IP address for the
instrument. Be sure to record the instrument's IP address to use in
instrument's internal web
Push the ENTER key or navigation wheel to confirm the changes.
Press the EXIT key to return to the LAN MENU.
From the LAN MENU, select APPLY_SETTINGS > YES, then press the ENTER key.
Select CONFIG > SUBNETMASK, then press the ENTER key. The SUBNETMASK
menu item is to the right of GATEWAY. Use the navigation wheel to scroll through the
options.
Modify the SUBNETMASK to match the PC settings recorded earlier or
255.255.255.000 if DHCP Enabled = YES.
Push the ENTER key or the navigation wheel when finished changing all the
characters.
Press the EXIT key to return to the LAN MENU.
From the LAN MENU, select APPLY_SETTINGS > YES, then press the ENTER key.
or subnet mask are applied.
used during the configuration of the instrument. This will ensure that
the system is using the correct network card.
Return to Section Topics
page.
Figure
Section 2: Remote Operation
Step 5: Access the
2-5).
2-7