Modifying A Factory Script - Keithley 2601A User Manual

Section 3: Test Script Processor Interaction
• Enter pulse OFF time.
• Enter number of pulses (points).
After the operator keys in each parameter and presses the ENTER key (or the navigation wheel),
the display will proceed to the next input prompt. After the last parameter (number of pulses) is
entered, the test will continue.
The following message will be displayed when the test is finished:
PulseVMeasureI
Test complete.

Modifying a factory script

A factory script can be imported from the Series 2600A into the Test Script Builder where it can be
modified. The modified script can then be loaded back into the Series 2600A and saved as a user
script.
The following procedure will import the KIGeneral factory script into the Test Script Builder, modify
code for the SourceVMeasureI function, load the script in the Series 2600A as a user script
under a different name, and then configure the test to call the SourceVMeasureI function.
Step 1: Importing a factory script project
A factory script project is made of many executable functions. The SourceVMeasureI function is
one of the functions that make up the KIGeneral factory script that is stored in the Series 2600A.
Figure 3-2
Test Script Builder. After importing the script, the project will appear as a folder in the Project
Navigator with a script file named "main.tsp" (see
3-6
shows how to import the KIGeneral factory script project from the Series 2600A into the
Return to Section Topics
Series 2600A System SourceMeter
Figure 3-3).
2600AS-900-01 Rev. B / September 2008
®
Instruments User's Manual