Quantum StorNext QD7000 Hardware Manual page 125

116 |
5. Connect the secondary host bus adapter for each host at this site to an available port in zone 1 of
switch 2.
6. Connect controller port A1 of the storage array to an available port in zone 1 of switch 1.
The figure following Step
7. Connect controller port B1 of the storage array to an available port in zone 1 of switch 2.
8. Connect controller port A2 of the storage array to an available port in zone 2 of switch 1. In a
four-host-port system, connect controller port A4 to an available port in zone 2 of switch 1.
9. Connect controller port B2 of the storage array to an available port in zone 2 of switch 2. In a
four-host-port system, connect controller port B4 to an available port in zone 2 of switch 2.
Ho s t Gro u p
Ho s t 1 Ho s t 2
HBA1a HBA1b HBA2a HBA2b
S witc h 1
0 2
4 6 8 10 12
Zo n e 2
Zo ne 1
1 3 5 7 9 11 13 15
S witc h 2
0 2 4 6 8 10 12
Zo ne 1 Zo n e 2
1 3
5 7 9 11 13 15
75083
9
on page 116 shows the cabling for E2700 controller-drive trays.
14
Zo ne 3
Zo ne 4
14
Zo ne 3
Zo ne 4