Installing/Removing Tailstock Center - Grizzly G0632 Owner's Manual

Tailstock Center
Installing/Removing
Tailstock Center
The included live center installs into the tailstock
quill with an MT#2 tapered fit.
To install the center into the tailstock quill:
1. Loosen the quill lock handle and rotate the
tailstock handwheel until the quill extends out
about 1" (see Figure 24).
Quill Lock Handle
Tailstock Handwheel
Figure 24. Installing center into tailstock quill.
2. Make sure the mating surfaces of the center
and quill are free of debris and oily substanc-
es before inserting the center.
3.
Insert the tapered end of the center into the
tailstock quill as shown in Figure 24.
4. Make sure the center is securely installed by
attempting to pull it out by hand—a properly
installed center will not pull out by hand.
5.
Make sure the center of the quill lock handle
is aligned with the quill keyway (see Figure
25) to ensure that the tailstock center and
quill will not freely rotate under load.
G0632 16" x 42" Variable Speed Wood Lathe
6.
To remove the center from the tailstock quill:
1.
2.
Quill
3.
The tailstock quill must always be locked in
place during lathe operation. Before tighten-
ing the quill lock handle, it must be properly
aligned with the quill keyway. Otherwise,
the workpiece can be thrown from the lathe
causing serious personal injury or death.
Quill Lock Handle
Figure 25. Quill lock handle aligned with quill
keyway.
Secure the quill in place by re-tightening the
quill lock handle.
Loosen the quill lock handle.
Hold a clean rag under the spindle or wear a
glove to catch the center when you remove
it.
Rotate the tailstock handwheel counterclock-
wise—the tailstock quill will retract back into
the quill causing the center to be forced out
of the quill.
Quill Keyway
-23-