Lock Set Up Group; Table 4-3 Lock Group (Numeric Code 200) Function Prompts - Honeywell UDC2300 Product Manual

Configuration

4.4 Lock Set Up Group

Introduction
The Lock Set Up group contains the Function parameters that will allow your indicator to
protect Configuration and Calibration data.
Because this group contains functions that have to do with Security and Lockout, it is best
to configure this group last, after all the other configuration data has been loaded.
Function Prompts

Table 4-3 LOCK Group (Numeric Code 200) Function Prompts

Prompt Numeric
English Code
SECUR 210
LOCK 211
22
Description
Security Code 0 to 4095
When "Lock" is none, this number is displayed
and can be changed using the raise/lower keys
Numeric
Code
Configuration
0
Lockout
1
2
4
UDC2300 Indicator Product Manual
Selection or Range of Setting
English
NONE – all parameters are
read/write
CAL - all parameters are read/write
except Calibration
CONF – Lockout is available for
Read/Write, other configuration
parameters are Read Only
ALL – Only the Lockout group is
available for read/write. No other
parameters are viewable.
Factory
Setting
DIS
CAL
10/00