3.1 Overview
This section gives you the information necessary to start up your indicator prior to
configuration. Review the Operator Interface portion to make sure you are familiar with
the indicator definitions and key functions.
3.2 Powering Up the Indicator
Apply Power
When power is applied, the
completed, "TEST DONE" is displayed.
Test Failures
If one or more of these tests fail, the
FAILSF will flash in the lower display and a message indicating which test failed will
appear in the lower display. Then, "DONE" will appear in the lower display.
10/00
3 Initial Start-up
will run three diagnostic tests. After these tests are
indicator
will go to the Failsafe Manual Mode, and
indicator
UDC2300 Indicator Product Manual
Initial Start-up
17