Configuration Procedure; Table 4-2 Configuration Procedure - Honeywell UDC2300 Product Manual

4.3 Configuration Procedure

Introduction
Each of the Set Up groups and their functions are pre-configured at the factory.
The factory settings are shown in Table 4-3 through Table 4-6 that follow this procedure.
If you want to change any of these selections or values, follow the procedure in Table 4-2.
This procedure tells you the keys to press to get to any Set Up group and any associated
Function parameter prompt.
Procedure
The prompting scrolls at a rate of 2/3 seconds when the [SET UP] or [FUNCTION] key is held in.
Also, [ ] [ ] keys will move group prompts forward or backward at a rate twice as fast.
Step Operation
1 Enter Set Up
Mode
Select any Set Up
2
Group
3 Select a Function
Parameter
4 Change the
Value or
Selection
Enter the Value
5
or Selection
6 Exit Configuration
10/00

Table 4-2 Configuration Procedure

Press
Upper Display = SET
SET UP
Lower Display = LOCK (This is the first Set Up Group title)
Sequentially displays the other Set Up group titles shown in
SET UP
the prompt hierarchy in Table 4-1.
You can also use the [ ] [ ] keys to scan the Set Up groups
in both directions. Stop at the Set Up group title that
describes the group of parameters you want to configure.
Then proceed to the next step.
Upper Display = the current value or selection for the first
FUNCTION
Lower Display = the first Function prompt within that Set Up
Sequentially displays the other function prompts of the Set
Up group you have selected. Stop at the function prompt that
you want to change, then proceed to the next step.
[ ] [ ] Increments or decrements the value or selection that
appears for the selected function prompt. If you change the
value or selection of a parameter while in Set Up mode then
decide not to enter it, press [MAN-AUTO/RESET] once—the
original value or selection is recalled.
Enters value or selection made into memory after another
FUNCTION
key is pressed.
Exits configuration mode and returns indicator to the same
DISPLAY
state it was in immediately preceding entry into the Set Up
mode. It stores any changes you have made.
If you do not press any keys for 30 seconds, the indicator
times out and reverts to the mode and display used prior to
entry into Set Up mode.
UDC2300 Indicator Product Manual
Result
function prompt of the selected Set Up
group.
group.
Configuration
21