Operator Interface; Entering A Security Code; Figure 5-1 Operator Interface - Honeywell UDC2300 Product Manual

Monitoring

5.2 Operator Interface

Introduction
Figure 5-1 is a view of the Operator Interface. A description of the displays and indicators
is included.
ALM - Alarm
conditions exist

5.3 Entering a Security Code

Introduction
The level of keyboard lockout may be changed in the Set Up mode. However, knowledge
of a security code number (0 to 4095) may be required to change from one level of
lockout to another. When an Indicator leaves the factory, it has a security code of 0 which
permits changing from one lockout level to another without entering any other code
number.
Procedure
If you require the use of a security code, select a number from 0001 to 4095 and enter it
when the lockout level is configured as NONE. Thereafter, that selected number must be
used to change the lockout level from something other than NONE.
Write the number on the Configuration Record Sheet in the configuration section so you will have a
permanent record.
34
Upper Display - Four digits
• Normal operation - Process Variable
• Configuration mode - displays parameter
value or selection
1 2
ALM
2300
MAN-AUTO
DISPLAY
FUNCTION
RESET
AUTO
TUNE

Figure 5-1 Operator Interface

UDC2300 Indicator Product Manual
F - °Fahrenheit being used
PV
C - °Centigrade being used
F
C
SET UP
RUN
HOLD
10/00