Preventive Maintenance; Establishing A Maintenance Program; Maintenance Schedule - Xtreme Manufacturing XR5919 Operation And Safety Manual

Preventive Maintenance

Establishing a Maintenance Program

The hour meter displays elapsed engine operating hours. Use
the hour meter and the schedules contained in this section to
establish a comprehensive preventive maintenance program.
Fig 87. Hour Meter, Display Style A
Fig 88. Hour Meter, Display Style B

Maintenance Schedule

Every Day or 8 Hours of Operation
See Pre-Operation Inspection Checklist
After First 50 Hours of Operation
Change engine oil and filters
Check air filter (replace if necessary)
Replace fuel filter and prefilter
Operation Manual
Check engine hoses and connections for leaks,
damage, and tightness
Check radiator hoses for leaks, damage, and tightness
Check electrical cables, leads, and connections for
damage and tightness
Check for oil and coolant leaks
Check condition and tension of drive belts (use
tension meter to check belt tension)
Lubricate front and rear driveshaft grease fittings
Lubricate front and rear axle grease fittings
Check wheel lug nuts torqued to 250 ft lbs
Lubricate boom pivot point grease fittings
Lubricate slide block contact areas
Replace hydraulic return line filter
Replace hydraulic filter on drive pump
After Every 50 Hours of Operation
Lubricate boom pivot point grease fittings
Lubricate rear axle grease fittings
Check tire pressure (80 psi)
After First 100 Hours of Operation
Top off axle wheel-end and differential oil
After First 200 Hours of Operation
Change axle wheel-end and differential oil & clean
magnetic drain plugs
64
Preventive Maintenance