Xtreme Manufacturing XR5919 Operation And Safety Manual page 59

Operation
Attachment Removal
NOTE: To remove a standard carriage with forks, spread the
forks apart on the carriage shaft. This provides adequate sup-
port for the carriage to stand alone.
1. Bring the forklift to a complete stop.
2. Move the travel select lever to NEUTRAL (N).
3. Set the parking brake switch to ON (engaged).
4. Extend the boom approximately 18 to 20 inches (0.46 to
0.5 meters).
5. With attachment 10" to 12" off of the ground, tilt the
attachment backward.
6. Disconnect the quick attach couplers (this only applies to
attachments with a quick attach hydraulic system).
Fig 77. Disconnect Quick Attach Couplers
7. Remove the quick attach pin keeper.
Fig 78. Remove Quick Attach Pin Keeper
8. Remove the pin at the bottom of the adapter.
Fig 79. Remove Pin from Attachment
9. Lower the attachment to the ground in a level position.
Fig 80. Lower Attachment to Ground in Level Position
10. Tilt and lower boom until pivot pins (A) have disconnected
from attachment hooks (B).
Fig 81. Pivot Pins and Attachment Hooks
11. Retract the boom to fully disconnect the attachment from
the quick attach adapter.
59
Operation Manual