Configuring With Thyro-Tool Pro Pc Software - Advanced Energy Thyro-PX Anybus Modbus TCP Manual

®
Advanced Energy
Table 3. Link/activity LED (Continued)
Green, flickering
Yellow
Yellow, flickering
Table 4. RJ-45 Ethernet pinout
1
2
3
6
4, 5, 7, 8
Housing
CONFIGURING WITH THYRO-TOOL PRO PC
SOFTWARE
You can configure the Thyro-PX power controller using either the Thyro-Tool Pro PC software or the
Thyro‑Touch display.
To configure the unit, you will:
• Adapt the Thyro-PX hardware configuration
If required, you can also:
• Select the configuration
• Configure the diagnostics
• Configure the flexible link parameters
Adapting Thyro-PX Hardware Configuration
Open parameter file with the unit online in the Port Explorer tab of the Thyro-Tool Pro PC software,
or use the Thyro‑Touch display.
Set the Anybus module slot to Modbus TCP in the Thyro-PX device hardware configuration:
57010166-00A
LED State
Pin
Thyro-PX
100 Mbit/s activity
10 Mbit/s link established
10 Mbit/s activity
TD+
TX-
RX+
RX-
Normally left unused; to ensure signal integrity, these pins
are tied together and terminated to PE via a filter circuit in
the module.
Cable shield
™ ®
Anybus Modbus TCP
™ ®
Thyro-PX Anybus
Description
Description
Modbus TCP
3