Mitsubishi Electric MELSEC iQ-R C User Manual page 44

Target data
The following shows the data that can be sampled at the time of data sampling in each sequence scan.
■Data type
Target data can be sampled as a data type in the following table:
Data type
Bit
Word
Double word
■Number of settings
Target data can be set up to 32768 points.
Note that the number of points that can be sampled for one control CPU module must not be exceeded.
MELSEC iQ-R CPU Module User's Manual (Application)
Precautions
When multiple intelligent function modules use the sequence scan synchronization sampling function, note the total number of
points for target data. If it exceeds the number of points that can be sampled, an error may occur in registration processing of
an intelligent function module registered later.
1 FUNCTION
42
1.6 Sampling Function
Number of device points
1 point
1 point
2 points