Installation From A Usb Memory Stick - Viavi T-BERD 4000 Base Unit User Manual

Installation
from a USB
memory stick
The update can be performed directly onto the equipment, using an http
address.
1 Connect the Product Name/Family Brand to a PC via an Ethernet
link.
2 On the Home page, press System Settings key to open the
System Settings page.
3 In I/O Interfaces, on the line Ethernet, select Mode: Dynamic.
4 In the Upgrade Server box:
– On the line Address Type, select Server Name or IP Address.
– Enter the Server Name (if Server Name has been previously
selected) or the Server Address (if IP Address has been previ-
ously selected)
5 In the I/O Interfaces box:
– On the line Use proxy, select No, Manual or Auto wether a
proxy is used or not.
6 Press, in succession,
Upgrade > Upgrade via
The message Verify IP address of PC server appears.
7 Click on Continue.
The list of the software versions available on the PC is displayed
next to the versions installed on the 4000 Platform (see
on page 202).
You must be equipped with a USB memory stick with a minimum capacity
of 128 Mo.
Before installing the upgrade, you must format the USB memory stick
(steps 1 to 5).
1 Insert the memory stick into one of the sockets on the 4000 Platform
provided for this purpose.
2 Switch on the 4000 Platform
H
3 Press the
OME
4 Successively select
Format.
5 Confirm your choice to actually format the USB memory stick.
6 Once formatted, disconnect the USB memory stick from the 4000
Platform using the key Eject USB in the Media Utilities page.
User Manual 77000000206 Rev. 007
Chapter 13 Maintenance and Troubleshooting
Installing a new version of the software
Expert Tools > Upgrades > Software
Ethernet.
button
Expert tools > Media utilities > Usbflash
Figure 132
203