Viavi T-BERD 4000 Base Unit User Manual page 158

Chapter 9 Ethernet TE Testing
Specifying test settings
136
Setting
Gateway
(Static IP mode)
DNS
(Static IP mode)
Use Vendor ID
(DHCP mode)
Use Vendor ID
(If Use Vendor ID
is Yes)
MAC Setting
VLAN
VLAN ID
VLAN Priority
6 Press the PPP soft key, and then specify the settings. The following
table describes the settings.
Setting
PPP Mode
User Name
User Manual 77000000206 Rev. 007
Description
Enter the gateway address.
Enter the address of the DNS server.
Specify whether the vendor ID is used.
Enter the vendor ID.
Specify whether the MAC is the factory default
or user defined.
Specify whether VLANs are used.
If VLAN is On, specify the VLAN ID.
If VLAN is On, specify the VLAN Priority.
Description
Select Client or Server.
Client is normally used. Use Server only when
you have a CO unit. This allows a remote
modem to establish a PPP session with the
Product Name/Family Brand.
NOTE: If you selected "Server" as the PPP
mode, connect only to other devices with the
same service name.
Enter a valid user name.
This must be a valid user account with an ISP.