Buffalo TeraStation User Manual page 9

12
Notes:
• By default, the TeraStation will attempt to use an NTP server to set the time.
• NTP may not be usable in some network environments.
• Read the terms of use for Internet Multifeed Co. at www.jst.mfeed.ad.jp. Internet Multifeed Co. is the
that manages the NTP Server at www.jst.mfeed.ad.jp. Internet Multifeed Co. is not responsible for any loss or
damages caused by this service.
• BUFFALO is not responsible for any loss or damage caused by using of this service, stopping the service, or
missing service.
• If your TeraStation fails to automatically obtain the time from NTP Server, verify the settings for the DNS server
address of the TeraStation. You must set a primary DNS server address to specify an NTP server by host name.
Otherwise you will have to specify the DNS server by IP address. You can change the DNS server settings at
Network - Settings - IP Address Settings in Settings.
13
The following settings changes are recommended.
Change your administration password
We recommend that you change the default password to a secure password.
1 Click Users/Groups - Local Users in Settings.
2 Select admin from the user list and click Edit User.
3 Enter a new password (twice).
-1
Click Save.
-2
Your administrator password is now changed.
Configure RAID Scanning
RAID Scanning checks your RAID 1, 5 or 10 arrays for problems and automatically fixes any errors it can. To
configure:
1 Click System - Storage - RAID Scanning - Modify Settings.
2 Click Enable for RAID Scanning.
3 Select the schedule to perform RAID Scanning.
Note: With Immediate checked, RAID Scanning will run immediately.
4 Click Save.
You have completed the settings for RAID Scanning.
TeraStation User Manual
1 To manually configure the date and time, click Manual for Date/Time
Source and adjust Date, Time, and Time Zone.
Note: Click Use Local Date/Time to use your computer's time (or Time Zone)
for the TeraStation's time.
2 Click Save.
group
8