Buffalo TeraStation User Manual page 144

System - Maintenance
Notification
SMTP Server Address
SMTP Port No.
Authentication Type
POP3 Server Address
POP3 Port No.
SSL/TLS
Email Notification
Username
Click Modify Settings
Password
to change settings.
Click Send Test
Subject
Message to send a
test email to the email
Recipient(s)
address which has
been set.
Report
Syslog
Syslog
Click Modify Settings
to change settings.
TeraStation User Manual
Select whether using Email notification feature or not.
Enter SMTP Server Address (Mail Server Address).
Enter SMTP Port No..
* The standard port number (25) is used if not specified. Also, User
authentication method is set to Disable or POP before SMTP, the standard port
number (25) is used regardless of the number you entered in this field.
Select Authentication Type from POP before SMTP, LOGIN(SMTP-AUTH), and
CRAM-MD5(SMTP-AUTH/CRAM-MD5).
Enter POP3 Server Address (Email server address).
Enter POP3 Port No..
* The standard port number (110) is used if not specified.
When LOGIN(SMTP-AUTH) and CRAM-MD5(SMTP-AUTH/CRAM-MD5) are selected
for Authentication Type, specify either using SSL or TLS.
Enter a user name that will be used for authentication.
Enter a password that will be used to verify.
Specify the subject of the email to be sent.
* Do not use multi-byte characters. It may cause the character corruption.
Enter the email address of the receiver, and click Add.
* You can register up to 5 email addresses as receivers.
Select the contents to send in the email notification.
• HDD Status Report
Sends the condition of the hard drives at the specified time on "HDD Status
Report".
• System Alert
Sends when system is rebooted or shut down, or RAID configuration is
changed.
• Disk Error
Sends when an hard drive error is recognized.
• Fan Failure
Sends when the fan error is recognized.
• Backup Complete
Sends when the backup is complete.
• Quota Report
Sends when the Quota Space Limitation is exceeded at the time which is
specified on HDD Status Report.
Select Enabled for Syslog Transfer and select Save to transmit the system log.
To view a log, select System Log, File Log (SMB), FTP Log for Logs To Transfer. You
can transmit the log by entering the IP address of the syslog server in "Syslog
Server IP Address" field when you select System Log, File Log (SMB).
* FTP Log does not support to output a log to the syslog server.
Store Files Locally
To store logs on the TeraStation, select Enable for Store Files Locally. Select
one of the TeraStation's shared folders as the Target Folder. A subfolder called
"system_log" will be created in that folder, and logs will be saved to that
subfolder.
* If you select File Log (SMB) or FTP Log, only file operations from internal hard
drives will be logged. File operations from USB drives will not be logged.
143