Tools Required For Assembly; Assembly - NOMA 052-4744-2 Instruction Manual

TOOLS REQUIRED FOR ASSEMBLY

This manual is designed to make it as easy as possible for you to assemble, install, operate and maintain
the ceiling fan. The following tools listed are required for assembly and installation:
1 x star-head screwdriver
After opening the package you should find all the necessary parts for installing this ceiling fan.
The box should also contain:
· 5 fan blades.
· 5 decorative fan blade arms.
· 1 motor with decorative housing.
· 1 light kit with complete installation hardware.
· 3 glass shades.
· 1 mounting bracket with complete installation
hardware.
· 1 receiver and remote control with complete
installation hardware.

ASSEMBLY

Preparing for installation
Getting ready
· Unpack and inspect carefully to make sure all parts are
included and not damaged (see Fig. 1). Lay all pieces out
on a working space.
possible electric shock (see Fig. 2).
Choosing a location for the ceiling fan
32" (81.3 cm) from adjacent walls or obstructions.
· Choose a location where there is a high enough ceiling clearance [at least 6' 11" (2.1 m) from the floor
to the ceiling fan's lowest moving part].
· Ensure that the outlet box in the room's ceiling can support the weight of the fan. Typically, if the
outlet box is marked "acceptable for fan support", it can hold the fan securely.
INSTALLATION
1. Mounting bracket
.
Remove the four sets of side screws from mounting
bracket and save for future use.
Normal masonry ceiling
. Securely attach the mounting bracket to an outlet box
marked " Acceptable for Fan Support ", using the
supplied outlet box screws with lock washers (see Fig. 3a).
Wooden ceiling
.
Drill two mounting holes in the ceiling joist.Securely
attach the mountingbracket to the wooden ceiling as
indicated below (fig. 3b).
1 x flat screwdriver
1 x wrench
1 x wire stripper/pliers
1 x electrical tape
Parts Pack Containing:
2 wood screws with flat washers.
2 mounting screws with lock washers.
1 extra blade bracket screws.
1 extra light kit screws.
16 Blade screws.
1 "J" hook.
2 tie wraps
1
3a
3b
Mounting
bracket
wood screw
1 x stepladder
2
Mounting bracket
Lock warshers
Outlet box screws
Flat
washer
3