NEC EXP320R Maintenance Manual page 141

Chapter 2 Configuring and Upgrading the System
6. Install a PCI card in a PCI slot.
Important
7. Close the latch and secure with one screw
removed in step 4.
8. Refer to 5.4.2 Installation in this Chapter and install the CPU/IO module.
9. Connect the power cords.
10. Press the POWER switch to power on the server.
11. Verify that POST displays no error message.
If POST displays an error message, write it down and see the POST error message list in Chapter 1
(6.2 (1) Error messages).
12. After the OS has started, proceed to steps in 5.7.5 Setup of Optional PCI Board in this Chapter.
Express5800/R320e-E4, R320e-M4, R320f-E4, R320f-M4 Maintenance Guide (VMware)
When you attempt to install the Fibre
channel card to the server, this may fail
due to interference by the SFP+ module
installed on the Fibre channel card.
In this case, remove the SFP+ module
from the Fibre channel card
beforehand, and install the Fibre
channel before installing the SFP+
module.
5. Installing and Replacing Optional Devices
141