Button Sewing - Bernina Bernette b37 Instruction Manual

42

Button Sewing

Stitch pattern:
Thread tension:
Presser foot:
Feed dog:
CAUTION:
Turn OFF the power switch before changing the foot.
Lower the feed dog. Set the slide speed control at low
speed setting.
Place the presser foot so that the back pin on the foot lines
up directly below the back notch of the presser foot holder.
Back pin
Notch on presser foot holder
Lower the presser foot holder and help with fingers to hold
der presser foot until it place. Raise the presser foot.
Place the button on the fabric, turn the handweel and pierce
the needle in the left buttonhole.
Hold the button in position by lowering the presser foot and
align the holes from the button horizontally to the presser
foot.
Turn the handwheel so that the needle will enter the right
hole of the button. Readjust the stitch width if necessary.
Stitch several times.
After the sewing process has finished, cut the thread. Keep
3 – 4 cm of the thread on the knob.
With a hand sewing needle, draw the top thread to the
reverse side of the fabric and knot the threads.
* After the button sewing is completed, raise the feed dog
for normal sewing.
05
3 - 7
Buttonhole sew-on foot T
Lowered