Bartack; Eyelet - Bernina Bernette b37 Instruction Manual

10 11 12 13 14
A A A F A
20 21 22 23 24
R R F F F
33 34
30 31 32
F F A F F
40 41 42 43 44
F F F F F
0 1 2 3 4 5
R A A A A A
10 11 12 13 14 15
A A A F A F
20 21 22 23 24 25
R R F F F F
30 31 32 33 34 35
F F A F F F
40 41 42 43 44 45
F F F F F F
38
15 16 17 18 19
F F F R R
25 26 27 28 29
F F F F F
35 36 37 38 39
F A A F F
45 46 47 48 49
F F F F F
6 7 8 9
A A A A
16 17 18 19
F F R R
26 27 28 29
F F F F
36 37 38 39
A A F F
46 47 48 49
F F F F

Bartack

Stitch pattern:
Thread tension:
Presser foot:
The bartack is used to reinforce pockets, crotches and belt car-
riers where extra strength is needed.
• Starting to sew
Start the machine and sew until the machine stops automatically.
The machine will sew a bartack 5/8˝ (1.5 cm ) long.
5/8˝ (1.5 cm)
• Sewing shorter bartack
* Set the slide speed control at low speed setting.
To sew a bartack shorter than 5/8˝ (1.5 cm), first stop the
machine after sewing the required length
reverse sewing button .
The bartack length has been determined.
Start the machine again and continue sewing until the machine
stops automatically.
Required length
Reverse sewing button
Bartack length
Starting point
• Sewing a same-sized bartack
Simply start the machine to sew another bartack at the same
size.

Eyelet

Stitch pattern:
Thread tension:
Presser foot:
The eyelet is used for belt holes etc.
Starting to sew
Attach the satin stitch foot F.
Start the machine. The machine will stop automatically when
completed.
Open the eyelet with an awl, eyelet punch or pointed scissors.
• Adjusting the shape of an eyelet
Correct the shape of the eyelet as follows:
Press the cursor buttons
value "L3" (default setting)
If the eylet is stretched , press the
even. (L1~L2)
If the eylet overlaps , press the
even. (L4~L5)
PLEASE NOTE:
The shape can be adjusted within L1 to L5 (default setting
is L3).
22
3 - 6
Satin stitch foot
, then press the
23
1 - 4
Satin stitch foot
to move the cursor under the
.
button to make the darn
button to make the darn