Cosori CP016-PC Manual page 20

TROUBLESHOOTING (CONT.)
Problem
Rice is half-cooked, too
hard, or burned.
Rice is too soft.
Burning smell is coming
from the pressure cooker
while it is operating.
Display shows Error Code
"E1".
Display shows Error Code
"E2".
Display shows Error Code
"E3".
Display shows Error Code
"E4".
20
Cause
There is not enough water added.
Cooker was opened too soon after
cooking has finished.
Too much water was added before
cooking.
There is not enough water added,
and food is burning.
There is food debris on the
heating plate or on the bottom of
the inner pot.
There is water on the heating plate
or on the bottom of the pot.
Broken circuit in the pressure
sensor.
Short circuit in the pressure
sensor.
Pressure cooker is overheating
because the inner pot has not
been placed properly, or has not
been placed inside the housing.
Pressure cooker is overheating
because there is not enough food
or liquid inside the inner pot.
Broken signal switch.
Solution
Add more water according to your
recipe.
After cooking has finished, leave the lid
on for 5-10 minutes.
Adjust the amount of dry rice and water
according to your recipe.
Add more water according to your
recipe.
Turn off the pressure cooker, allow it to
cool down, and clean the heating plate or
bottom of the pot.
Thoroughly dry the exterior of the inner
pot before each use.
Immediately stop using the pressure
cooker. Contact Customer Support (page
22).
Immediately stop using the pressure
cooker. Contact Customer Support (page
22).
Properly place the inner pot into the
housing.
Stop the cooker and add more
ingredients and liquid. At least 1 US cup
(240 mL) of water or water-based liquid is
required for pressure cooking.
Immediately stop using the pressure
cooker. Contact Customer Support (page
22).