Supermicro X11DDW-L User Manual page 95

Confi gure sSATA as
Select AHCI to confi gure an sSATA drive specifi ed by the user as an AHCI drive. Select RAID
to confi gure an sSATA drive specifi ed by the user as a RAID drive. The options are AHCI
and RAID. (Note: This item is hidden when the sSATA Controller item is set to Disabled.)
SATA HDD Unlock
Select Enable to unlock sSATA HDD password in the OS. The options are Enable and Disable.
sSATA RSTe Boot Info (Available when the item "Confi gure SATA as" is set to
"RAID")
Select Enable to enable full int13h support for devices connected to the SATA controller which
will allow these SATA devices to be used as boot devices for system boot. The options are
Disable and Enable.
Aggressive Link Power Management
When this item is set to Enable, the sSATA AHCI controller manages the power use of the
SATA link. The controller will put the link in a low power mode during an extended period of
I/O inactivity, and will return the link to an active state when I/O activity resumes. The options
are Disable and Enable.
sSATA RAID Option ROM/UEFI Driver (Available when the item "Confi gure SATA as"
is set to "RAID")
Select EFI to load the EFI driver for system boot. Select Legacy to load a legacy driver for
system boot. The options are Disable, EFI, and Legacy.
sSATA Port 0 - sSATA Port 5
Hot Plug
Select Enable to support Hot-plugging for the device installed on an sSATA port selected by
the user which will allow the user to replace the device installed in the slot without shutting
down the system. The options are Enable and Disable.
Spin Up Device
On an edge detect from 0 to 1, set this item to allow the sSATA device installed on the
sSATA port specifi ed by the user to start a COMRESET initialization. The options are
Enable and Disable.
sSATA Device Type
Use this item to specify if the device installed on the sSATA port specifi ed by the user
should be connected to a Solid State drive or a Hard Disk Drive. The options are Hard
Disk Drive and Solid State Drive.
95
Chapter 4: BIOS