Table of Contents
Advertisement
EU Declaration of Conformity
Manufactured by:
Finish Thompson, Inc.
921 Greengarden Road
Erie, Pennsylvania 16501 U.S.A.
Phone: 1-(814)-455-4478
Fax
1-(814)-455-8518
Email:
fti@finishthompson.com
Web:
www.finishthompson.com
Finish Thompson declares under our sole responsibility that the product listed below conforms to the relevant
provisions of EU directive 2014/34/EU of 26 February 2014 for equipment and protective systems intended for use in
potentially explosive atmospheres, and is certified for safe use in Atmosphere Group IIC/IIIC category 2 areas.
This declaration applies to Finish Thompson, Inc ATEX DB Series pumps only manufactured out of carbon fiber filled
PVDF with a conductive motor adapter and non-sparking ring designated by the letter "V" and "A" in the model
number. Pumps and their model number may also contain many different combinations of bushings, shafts, o-rings, port
connections, impellers, magnet sets, motor adapters and other options.
Models: DB6V-A, DB6HV-A, DB7V-A, DB8V-A, DB9V-A, DB10V-A, DB11V-A, DB15V-A & DB22V-A.
This product has used the following harmonized standards to verify conformance:
Non-electrical equipment for potentially explosive atmospheres: EN ISO 80079-36:2016
Basic Methods and Requirements.
Non-electrical equipment intended for use in potentially explosive atmospheres: EN ISO 80079-37:2016
Protection by construction safety "ch." and control of ignition source "bh"
This product must not be used in areas other than specified above. If in doubt consult an authorized distributor,
or refer to the manufacturer Finish Thompson.
Approved by:
FTZU 06 ATEX A136-06 FTZU 08 ATEX A174-08
FTZU 07 ATEX A166-07
3
1026
II 2GD
Ex h IIC T6...T4 Gb
Ex h IIIC T6...T4 Db
Date: 5/5/2017
Advertisement
Table of Contents
