Install Rails (Square, Round, Pre-Tapped Hole-Racks) - Quantum QXS-448 Drive Rackmount Install Manual

Install Rails (Square, Round, Pre-tapped Hole-Racks)

Install Rails (Square, Round, Pre-tapped
Hole-Racks)
This section provides the rail installation of three different types of racks. Information is as follows:
Square Hole-Rack Rail Installation below
l
Round Hole-Rack Rail Installation on page 12
l
Pre-tapped Hole-Rack Rail Installation on page 16
l
Square Hole-Rack Rail Installation
Complete steps 1–4 to install the rails.
1. For square-hole racks, install cage nuts in the front rack holes where chassis ears will be attached.
a. Before rail installation, refer to
of the chassis.
Figure 5: Screws and Cage Nuts for Chassis Front
4
3
4
3
1. Left Rail
2. Right Rail
b. Before rail installation, refer to
the rear of the chassis.
QXS 48-Drive Rackmount Install Guide
Figure 5 below
1 2
3. Screws Installed into Threaded Holes in Rail
4. Cage Nut Installed (for chassis screws)
Figure 6 on the next page
for location of screws and cage nuts for the front
3
4
3
4
for location of screws and cage nuts for
7