Yaesu FT-1000MP Operating Manual page 94

Menu Programming
-
Selection & Settings
Rx Carrier - This is used to adjust the receive
carrier injection frequency between 450-460 kHz.
The default injection frequency is dependent
upon operating mode.
Tx PLL Offset
-
You can offset the transmitter
PLL frequency f5.000 kHz (in 5-Hz steps) when
the
USER
button is pressed.
Tx Carrier
-
This is used to adjust the transmit
c a r r i e r i n j e c t i o n f r e q u e n c y b e t w e e n
456.300-460.000 kHz (in LSB and PKT),
450.000-453.700 kHz (USB), or between
450.000-460.000 kHz (all others). The default
injection frequency is dependent upon operating
mode.
RTTY Offset (shift)
-
For operators who desire
to use a non-standard marWspace shift (that is,
other than 17014251850 Hz), a custom shift
(k5.000 kHz in 5-Hz steps) can be chosen. The
mark is the carrier frequency, while the space is
offset above or below the carrier by the value of
this setting. For best results, we recommend lim-
iting shift to +I ,000 kHz or less.
Easy Set
-
If you enjoy operating FAX or SSTV,
you can select on of these for the User mode. The
carrier and offset options for both settings come
factory pre-configured and optimized for best op-
eration.
SUB VFO Receiver AGC
-
Select automatic,
slow, or fast AGC recovery time for the Sub VFO-
B receiver.
Antenna Tuner
-
Enable or disable the internal
automatic antenna tuner unit for operation.
Carrier Point Offset
-
This allows shifting the
carrier point IF passband on both Tx and Rx to
tailor the received audio response, as well as your
transmitted voice audio. This can be used to cus-
tomize your signal for your own voice charac-
teristics. Seven individual carrier settings are
selected with the SUB VFO-B dial, while offsets
are adjusted (in 10-Hz steps) using the MAIN
VFO-A dial:
Rx LSB Carrier - Adjust the receiver carrier
point for LSB throughout the range of -200
-
9500 Hz.
Tx LSB Carrier
-
Adjust the transmitter carrier
point for LSB throughout the range of -200
-
+500
Hz.
Processor LSB - Adjust the speech processor
carrier point for LSB throughout the range of -200
-
+500 Hz.
Rx USB Carrier - Adjust the receiver carrier
point for USB throughout the range of -200
-
+500
Hz.
Tx USB Carrier - Adjust the transmitter carrier
point for USB throughout the range of -200
-
+500
Hz.
Processor USB
-
Adjust the speech processor
carrier point for USB throughout the range of -200
-
9500 HZ.
Tx AM Carrier
-
Adjust the transmitter carrier
point for AM throughout the range of k3000 Hz.
L G F
Notes See the table on the next page for a
complete list of filter offsets according to mode,
and custom frequency and display offsets.
Several frequently-used menu functions can
be accessed directly via two keystokes from
Hold while pressing
...
to access:
FAST VCCIMIC
4-5 EDSP-Fil
FAST
RX-(Sub VFQ) 8-7 SUB AGC
page 92