Yaesu FT-1000MP Operating Manual page 23

( 2 2 )
~c
1 3 . 5 ~
DC Cable Socket
(24)
FUSE
Holder
This 6-pin molex socket accepts DC input
This holder requires a 8-A fuse for operation
power to the transceiver if the internal switching
from AC voltages below 125 V, and an 4-Afuse for
power supply is not installed, or when AC is not
AC voltages of 200 V and above. Only normal
available.
fast-blow type fuses should be used here.
(23)
nc
Line Cord Socket
Coranect "re supplied AC line cord to this
socket
after
ensuring that your AC mains voltage
matches "rat on the label. See the Installafion
sectisn
for instructions on how to change the
internal switching power supply AC mains volt-
age, if necessary.
The volume of the beep that sounds when a
front-panel button is pushed can be adjusted
by turning a trimmer accessed via the small
hole
on
the bottom cover of the transceiver.
InsePa:
a small, thin, insulated, flat screwdriver
into the hole to adjust VR3001 for the desired
beep volume. Beep tone is adjusted via menu
programming and discussed later in the
-
page 21