Yaesu FT-1000MP Operating Manual page 66

I
I
Operation
DVS-2 Digita Voice Recorder
Overview
The DVS-2 is a digital voice recorder designed
especially for SSB, AM, and FM operation with
newer model Yaesu transceivers having a special
jack for connection of the DVS-2 on the rear
panel. It offers two independent functions:
recording received signals for playback later
in the loudspeaker or headphone,
D VS-2 C O P ~ ~ U O ~ S
( I ) , (2), & (3): PLAY, REC & TX LEDs
These LEDs light or flash to indicate the status
of the DVS-2. The
PLAY
LED glows green when
playing back stored data, the
REC
LED glows
yellow when recording, and the
TX
LED glows red
when the DVS-2 is keying the transmitter to play
back over the air. Also, the
PLAY
and
REC
LEDs
flash when waiting for you to make a memory
selection (with a numbered button).
(4) MESSAGE MODE Slide Switch
This selects the mode for recording messages
to be played back over the air: for either two
8-second messages, or four 4-second messages.
Changing your selection does not erase pre-
viously stored messages, so you can use this
switch to combine two pairs of 4-second mes-
sages.
(5) MESSAGE NR Selection Buttons & LEDs
These buttons select which message slot to re-
cord via the microphone or play back over the air.
The LED above each button glows red when a
message has been stored in that slot. The
3
and
4
keys (and LEDs) are only functional when the
*
recording signals by the microphone for
MESSAGE MODE
switch is set to the
4
x
4 SEC
playback over the air (during transmission).
position.
Each mode uses its own memory, so both
(6) MONI Button
modes can be used to retain data at the same
After recording a message via the microphone,
time. Operating details are provided with the
press this button (followed by a message number
DVS-2, but a summary is provided here.
button) to play back that message in the loud-
speaker (instead of over the air).
Installa f ion
(7)
MEMO Button
Connect the DVS-2 cable to the DVS-2 jack on
Press this button (followed by a message
the rear of the transceiver.
DVS-2
number button) to record a message via the mi-
You must also have a micro-
V ~ I ~ E
OUT
crophone.
phone connected to the
MlC
jack on the front panel of the
(8) PLAY Button
transceiver to record your
c , T , , ~ ~ * ~ , , ,
After recording received signals, press this but-
voice for transmissions.
as vlewed from rear panel
ton to play them back in the transceiver's loud-
speaker.
(9) REC Button
Press this button to start the receiver recorder.
The recorder will run continuously (recording an
16-second loop) until you press the
STOP
button.
(1 0) STOP Button
Press this button to stop any recording or play-
back operation.
page 64