Yaesu FT-1000MP Operating Manual page 19

These appear indicating the selected clarifier
function
(Rx?
Tx or both). The clarifier offset fre-
quency
(i9.99
kHz) is shown in the sub-display
immediately to the right.
(1 9)
Appears when an abnormally high SWR cmdi-
tiara exists that cannot be matched below 3.0:1.
lnciicates the antenna selected for operatisn (A
or B) by the front panel
NB
switch (see item
18 on pages 10-1 1).
(21 )
When the
MEM GROUP
button is pressed, this
indicates memory recall, and scanning is limited
to those memories in the currently selected group.
(22)
Indicates the selected memory channel is not
yet filled with data.
(23)
t
External computer control of the transceiver is
active,
(24) Multi-Display Window
Displays either the clarifier offset, memory
channel frequency, split frequency offset, or CW
pitch,
Clarifier Offset
L
/
M CH Frequency
Split Offset
(VFO A
-
VFO B)
CW Pitch
(carrier offset)
When enabled, shows the frequency differ-
ence (split offset) between Main VFO-A and Sub
VFO-B.
Appears when the memory channel frequency
appears in the multi-display panel.
(27) Memory Channel Box
Memow
During normal operation,
the currently-selected mem-
H
ory group and memogr chan-
Group
nel number appear here. With
NO.
the Menu Programming mode active, menu selec-
tion numbers are displayed.
Appears while tuning within programmed fre-
quency limits in the PNIS (Programmed Memory
Scan) mode.
Sub Receiver Display Indications
(1)
Frequency Display
Displays the current sub-receiver frequency
used during dual receive operation, and the trans-
mit frequency during split operation.
(2)
S-Meter
Displays relative signal strength.
(3)
LOCK
Appears when the Sub VFO tuning knob is
disabled (it still turns but does nothing).
(4)
MODE
Displays the currently-selected operating
mode for the Sub receiver.
3
page 17
$
d a