Transverter Operation - Yaesu FT-1000MP Operating Manual

Operation
Trans verter Operation
Two station setup examples are shown below.
The example uses the
RxnNTiN
jack, which allows
keeping the installed HF antenna connected di-
rectly to the transceiver. The
TRV
output from the
rear panel of the tranceiver must be connected to
the
RF IN
jack of the transverter.
Transverted Frequency Display
You may want to use menu selection 3-3 to
change to the MHz digits to a transverted
frequency display readout (50, 144, 430) at
C7 During transverter operation, move the ALC
Unit witch
f~
the open position, and adjust
the
RF PWR
control fully clockwise.
0 If using Example # I , press the
Rx ANT
switch to
receive the "transverted" (downconverted) VHF
input. Press to select 28 MHz for operation
and refer to the documentation provide with
your transverter for tune-up and operation.
HF
ANT
Adjust TRV Drive
Level For Maxirnu
FT-1000MP
Example of TransveHer Station Interconnections
page 70