Quadivator ST50 Assembly/Operators/Parts Manual page 25

7.7 Adjusting the ST50 Discharge Spout
CAUTION
To adjust – loosen the two tension bolts on either side of the discharge spout,
move to desired position of the spout and then re-tighten the two bolts!
If the spout moves during operation and must be re-adjusted - Avoid Injury!
Before adjusting the discharge spout, Disengage drive – STOP the engine! Wait
for the Impeller to STOP before attempting to adjust the discharge spout.
7.8 Transporting of the ST50 Snow Thrower
When transporting a ST50 w. ATV on a trailer – use a trailer with legal lights:
- drive the ATV & ST50 to the trailer deck
- lower the ST50 to the trailer deck and
- stop the ATV Engine
- securely strap the ATV and ST50 to the transporting trailer!
Avoid Injury!
spout, Disengage drive – STOP the engine!
Wait for the Impeller to STOP before attempting to
adjust the discharge spout.
Before adjusting the discharge
Discharge spout
adjust bolts!