Quadivator ST50 Assembly/Operators/Parts Manual page 18

Step 8
– Thoroughly check all drives, belt routing and chain tension.
NOTE – initially direct the spout as low as possible and directly away from the
operator for start up!
Step 9
– Start the engine, engage the clutch just above idle, then run the engine
to maximum RPM, and allow it to operate for several minutes to reach operating
temperatures in all of the drives.
Level from side to side from
the ground with spacer from
the scraper blade to ground.
Chain drive behind the guard
on the LHS of the ST50.
Skid shoe adjust up and
down via slotted bolts.
Lift height need be no more
than 4.0" to the ground.